Input Voltage Range	140 – 280 V AC
Input Frequency	47 – 53 Hz
DC Voltage	12 V / 24 V / 36 V/ 48 V/ 72 V DC
Output Voltage	200 - 240 VAC
Output Frequency	50 ± 0.5 Hz
Display	Full Digital display to show every state of Inverter.
Wave Form	PWM-Quasi Square Wave
Battery Type	Lead Acid / Tubular
Load power Factor	0.8
Indication	Mains Normal, Mains High, Mains failure, Load on Mains / battery,Battery Charging, Battery Low, Inverter Overload.
Protections	Under / Over Voltage, Overload, Low Battery & Short circuit
Alarms	Low battery, Overload,
Operating Temperature	0 - 50°C
Rating Available	2000 VA – 5500 VA

S. No.	Condition	LCD Display Indication	Details / Narration
01	Load on Main’s Input Voltage	Inverter On Mains Battery Charging	Indicate’s that the Mains voltage is available to inverter & the Inverter is charging the batteries.
02	Load on Main’s Input Voltage	Inverter On Mains Battery Volts	Indicate’s that the Mains voltage is available to Inverter & it will display the battery Volts to ascertain the charging status of batteries.
03	Load on Battery (Mains Off)	Inverter On Battery Discharging	Indicate’s that the Mains voltage is not available to inverter & the Inverter is on battery Mode.
04	At Full Load	Inverter On Battery Discharging	Indicates that the load on inverter is as per inverter capacity.
05	At Appx. 10 % Overload	Overload Reduce Load	Indicates that the load is more than the Inverter capacity, so load should be reduced. It will give beep sound until the load is reduced.
06	On Reducing Load to inverter capacity	Inverter On Battery Discharging	When the load is reduced from the above condition then the Inverter returns to Normal Mode & stop giving beep sound.
07	Battery Low	Battery Very Low Please switch off	Indicates that the batteries are fully discharged so Inverter should be switched Off in this condition.

Functions as an extended run standalone power source for household and industrial appliances.

High and low voltage cut-off for the safety of appliances attached through the inverter.

Battery run time is dependent upon the size of the battery connected.

Converts 12 volt DC to 220 volt AC.

Mosfet based PWM technology.

Controlled PWM based pulse charging.

Automatic Overload Reset with Audio/ Visual Alarm.

Automatic changeover to battery mode at Input below 120 V AC & above 280 V AC.

Automatic Alarm for Low Battery.

Low battery shutdown.

Low Noise (<35 db at 1mtr.)